Advanatges and Benefits of Laser cutting

One of the best benefits of a laser cutter is that it’s economical to use laser cutting even for limited-run projects. This is because a laser cutter does not use any kind of tooling that must be custom-built or modified for your project. It also does not have physical cutting surfaces which wear out.

To create a component or part with a laser cutter, all you need is a material to cut, a laser cutter, and a schematic which can load into the computer. This reduces overall costs even for small-batch projects, particularly when compared to traditional tooling and manufacturing.

Laser tools also have fewer mechanical moving parts, which reduces maintenance and operations costs and helps keep the cost of using a laser cutting company low.

There is no job that is too complex for a laser cutter. The high-power laser can use  on a very narrow section of material and causes very little warping or distortion to the area being cut.

With the proper schematic, a laser cutter can use to quickly and easily create even the most highly-complex geometries and cuts with unparalle precision and excellent tolerance levels.

Another benefit of the precision and accuracy of laser cutting is that it can utilize a very high percentage of your sheet material. By nesting cuts properly, a laser cutter can maximize the number of usable components and parts from any given sheet of material.

Again, this leads to lower overall costs for your project and faster completion times. Less time is needed to swap in new sheets of material, and less of your raw material waste by the machining and cutting process.

A common misconception about laser cutting is that the high heat causes a lot of distortion and warping. But this is not true. The Heat Affected Zone (HAZ) of laser cutting is actually quite small, and typically causes no issues with the tolerance of the part or component.

Because of this, lasers are actually ideal for cutting extremely thin materials. The laser cuts through the material so quickly that it will not become excessively hot and warp. The HAZ is so small that it can be easily machined away, if necessary.

While the laser use to cut materials uses quite a bit of energy, laser cutters do not have any other moving parts – unlike presses and some other cutting tools, which require enormous amounts of energy to deliver cutting force using a physical die.

When it comes to laser cutting advantages, this is an important benefit. Laser cutting can use for a huge variety of different tasks, and not just cutting through a material completely. Lasers can also use for drilling, marking, and engraving, just to name a few functions – without needing to replace or switch any tooling.