How to maintain&clean fiber laser cutting machine-Yan

How to make the machine clean and  work well?

1.Clean the surface of the equipment to attach dust and cut slag

Fiber laser cutting machine-Nancy
keep fiber laser cutting machine clean.

2.Check the joints of the capacitor signal module (at the cutting head) to confirm that the fastening is intact and there is no looseness.

3.Clean up the water in the A/C storage tank

4.Equipment homing (including X, Y and Z axes)

5.Cleaning waste scraps and debris in waste trailers

6.Check the lubricating oil level in the lubricating oil pump.

7.Clean the dust on the A/C dust cover net and the water cooler dust cover net.

8.Check the lubrication condition of each shaft slide rail, rack, gear and z-axis screw; and manually add lubricating oil on the upper end surface and the two end surfaces of the guide rail, and the main mechanical linkage end face of the rack, gear and lead screw is evenly distributed. Apply lithium grease. (If there is rust, be sure to remove the rust first.)

9.Check the water pipes of the cooling water pipe to confirm that there is no extrusion, bending, grinding, scratching and water leakage; check the water pipe joints (push-in connectors and ordinary threaded joints) to confirm that the connection is normal and there is no water leakage.

10.Check if the cooling water pressure gauge value is normal.

11.Clean the water tank of the water cooler.

12.Replace the water cooler to circulate cooling water.

13.Replace the water cooler filter.

14.Clean the water filter of the water cooler.

15.Check whether the crimping of each terminal of the terminal block in the electrical cabinet is firm, and whether the electrical plug connectors are firmly connected, confirm that there is no looseness.

16.Check the wiring harness and cable everywhere, and confirm that there are no extrusion, bending, grinding, and scratching. There is no open welding or short circuit or hidden trouble in the welding of the break point and the plug joint.

17.Clean up dust in the electrical cabinet.

18.Check the top wire of the reducer under each axis motor to confirm that it is not loose.

19.Check the center of the beam to make sure it is concentric with the nozzle hole.

20.Check the protective lens to make sure it is clean and free of dirt.

21.Clean the nozzle, nozzle fastening ring, ceramic ring, ceramic ring fastening ring, dust and slag between the height sensors.

22.Clean the dust and slag on the lead screw and Z-axis guide rail.

23.Clean the surface of the cutting head and focus on cleaning the cooling water pipe joint, auxiliary gas joint, protective lens window, QBH/QCS joint and other parts.

24.Check all parts of the fiber optic cable to confirm that there are no extrusion, bending, twisting, rubbing or scratching.

25.Check the grounding protection end of the device to confirm that the connection is intact.