Setting marking parameters in fiber laser marking machine software-Angelina | XTLASER

Setting marking parameters in fiber laser marking machine software-Angelina

Setting marking parameters in fiber laser marking machine software

Today we will share some tips when using fiber laser marking machine.

In marking metal and plastic,There is a setting parameter range for reference to test.

Speed 100-2000 adjustable,Power 30-80 adjustable,Frequency 5-30.

Here have a brief introduction about fiber laser marking machine frequency,power,speed and the hatch function .

These four settings will affect the marking result in order to get a good laser marking result we need to adjust the speed power and frequency.

1.)  In laser marking machine,Marking frequency stands for the times of laser pulse per unit time is called the marking frequency.

It is easy to understand.

For example, When the value of marking frequency is high.

The laser spot is dense on the contrary if the marking frequency value is low then the laser spot is parse.

Although the laser spot can not be seen by the naked eye,we can see it when we put the marking workpiece under the electron microscope.

The continuous line we see by eyes turns out that is composed by many laser spots.

The high value we set at marking frequency,the denser laser spot we get and more smoothness we will get on the marking workpiece.

2.)  Marking speed refers to the moving speed of the fiber laser marking machine.

Here this speed is the speed that can be adjusted in the parameters for marking.

The overall marking time is not only affected by marking speed.

But also by the marking depth, marking area and other factors.

The higher speed you set,The faster marking speed you get.

Fast marking speed means less laser hitting times in the same marking place.

Slow speed is more conducive to deep marking .

But it does not mean the slower speed you set, the better depth you will get.

It also depends on the different materials and other relative parameters you set at.

If the marking speed is too slow, the substance that burns by laser will accumulate on the surface of the material.

And affect the laser to engrave deeper.

When you are doing deep marking,It is better do a high speed marking after a few times of low speed marking.

In this way you will get better marking result.