How to Choose the Auxiliary Gas of Fiber Laser Pipe Cutting Machine?-Serena

How to Choose the Auxiliary Gas of Fiber Laser Pipe Cutting Machine?

When using fiber laser cutting machine, it need to be equipped with auxiliary gas. This is also applied to fiber laser pipe cutting machine. Auxiliary gas choose usually contains oxygen, nitrogen and compressed air.

The applicable conditions for the three gases are different. So the following are the differences of them.

1. Firstly,Compressed air

Compressed air is suitable for cutting aluminum sheets and galvanized steel sheets, which can reduce the oxide film and save costs to some extent. Generally, the cutting sheet is relatively thick, and the cutting surface is not required to be too perfect.

2.Secondly, Nitrogen

Nitrogen is a kind inert gas. It prevents sheet surface from oxidation during cutting, and prevents burning (it is easy to occur when the sheet is thick).

3. Thirdly,Oxygen

Oxygen mainly acts as a combustion aid, which increases the cutting speed and thickens cutting thickness. It is suitable for thick plate cutting, high speed cutting and sheet cutting,such as some large carbon steel plates, thick carbon steel structural parts.

Although increasing the the gas pressure can improve the cutting speed, the high cutting speed also will cause a decrease after reaching a peak vaortant to contrlue. Therefore, when debugging the machine, it is very impol the air pressure.

XTLASER provides all day and night service to you.Our engineers has served many countries and regions around the world. If your machine has any problem, engineers willl help you by online or on-site.

Any interest,please contact us without hesitate

email:xintian115@xtlaser.com

whatsapp:+86 15806603572

    Get a Quote

    Need Help?

    Fill out the form below and support will be available within the hour!