Installation steps of fiber laser cleaning machine 2-Ivy

Let us continue to talk about the Installation steps of fiber laser cleaning machine.

Step 6: Display control operation.

First, The boot page is show below.

Then, Enter the parameter setting page, Power (%) is the percentage power, and Freq (Khz) is the actual frequency value, as show below;

And,Make the parameter settings, click on the number with your finger, the number table appears, select the parameter. And finally press Enter to confirm.

And,Click the “ ” button in the lower right corner of the parameter setting page, the parameter setting is complete. If you need to reset the parameters. Click the“ ” button at the bottom of the screen to re-enter the parameter setting interface.

Step 7: Press the “Control” button in the figure.

Step 8:Then, The cleaning head is direct to the surface of the work piece to clean. And the button at the handle of the cleaning head is press to perform the cleaning operation.

Step 9: Cleaning head working knob Description. “Width” adjusts working width, quick joint is blowing joint Note. For safety, please be sure to connect compressed air to ensure that there will be no dust in the outlet.

Step 10: After use, turn off the power in the reverse order.

Advantages of laser cleaning machine:

First,non-contact cleaning, does not damage the part substrate.

Second,precise cleaning, can achieve precise location, the exact size of the selective cleaning.

Then,laser-cleaning-machine without any chemical cleaning fluid, no supplies, safety and environmental protection.

And,simple operation, power can be hand-held or with the robot to achieve automated cleaning.

Also,cleaning efficiency is very high, save time.

And laser cleaning system is stable, almost no maintenance.

For  more info. of Installation steps of fiber laser cleaning machine,pls contact us at Whatsapp:0086 17864184107.

 

    Get a Quote

    Need Help?

    Fill out the form below and support will be available within the hour!