What to pay attention to when using the cutting machine-Serena

What to pay attention to when using the cutting machine

Now fiber laser cutting machine has became more and more popular in metal progress industries.More and more company chooses fiber laser cutting replaced the original.

Then what to pay attention to when using the cutting machine we need.The following are some tips for your rederence:

Attention when using the cutting machine:

1. Firstly,Observe the general safety regulations for laser cutting machines. Start the laser in strict accordance with the laser startup procedure.

2.Secondly, The user must be trained. Familiar with the equipment structure and performance. And master the relevant knowledge of the operating system.

3. Thirdly,Wear protective gear according to regulations. And you must wear appropriate protective glasses near the laser beam.

4. Do not process a material without knowing whether it can be irradiated or heated. So that avoid the potential danger of smoke and vapor.

5. When the laser cutter is running, the operator shall not leave the post or entrust the management without authorization. If it is really necessary to leave, the laser cutter operator shall stop or cut off the power switch.

And more

6. Keep fire extinguishers within easy reach; turn off lasers or shutters when not processing. Do not place paper, cloth, or other flammable materials near unprotected laser beams.

7. When an abnormality is found during laser cutting. The machine should be shut down immediately.And the fault should be rectified or reported to the supervisor in time.

8. Keep the laser generator, frame and surrounding area clean, orderly. And free of oil pollution. Workpieces, plates, and waste materials should be stacked in accordance with regulations.

9. When using gas cylinders, avoid damaging the welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder monitoring regulations. Do not expose cylinders to direct sunlight or heat sources. When opening the bottle valve, the laser cutter operator must stand on the side of the bottle mouth.

10. After starting the laser cutter, manually start the laser cutting machine at low speed in X and Y directions, and check whether there is any abnormal situation.

11. After entering the new workpiece program, it should be tested first and checked for its operation.

12. When working, pay attention to the operation of the machine to avoid the laser cutter out of the effective stroke range.

Any more interest,pls contact XT laser freely.We are a laser cutting machine manufacturer in China for 16 years.We could provide you the most professional laser machines



    Get a Quote

    Need Help?

    Fill out the form below and support will be available within the hour!