Operation of fiber laser cutting machine-Flora

Operation of fiber laser cutting machine

iber laser cutting machine has now become an indispensable modern sheet metal industry processing equipment, with the upgrading of the industry, the processing requirements of the upgrade, not only in the efficiency of a very high upgrade in the optimization of the operation is to do the ultimate , The following to tell you about the specific operation process.

Auxiliary gas of fiber laser cutting machine
Auxiliary gas of fiber laser cutting machine

Fiber laser cutting machine operation steps:

1. Determine the need to process the material, the sheet metal material fixed flat on the machine, and then determine the stability of the material placed in order to avoid jitter in the cutting process, resulting in cutting accuracy can not meet the requirements.
In the case of
2. Operate the console, enter the product cutting pattern, and cut the material thickness and other parameters, and then adjust the cutting head to the appropriate focus position, and then reflect and adjust the nozzle center.
In the case of
3. Start the regulator and the chiller, set the water temperature of the chiller and the water pressure.
In the case of
4. Start the laser and then turn on the machine.

Although the above four points are very short, but in the actual operation of the process have to spend a lot of time to practice, to familiar with each operation details. It is inevitable in the operation of fiber laser cutting machine, there will be some problems.

Familiar problems happened in fiber laser metal cutting machine:

1. Boot without any reflection

If power fuse burned: Replace the fuse.
Power input is normal: Check the power input and make it normal.
The main power switch broken: replace the total power switch.

2. No laser output or laser is weak

Light path is offset: carefully adjust the optical path.
Whether the focus change: Adjust the focus.
If the laser tube broken: Replace the laser tube.
Whether the laser power is energized: Check the laser power supply circuit to make it normal.
Laser power broken: replace the laser power.

3. The processing size has errors or errors

Is the signal line normal: replace the signal line.
Power supply is unstable or interference signal: install the regulator or remove the interference signal.

Whether the processing parameter is correct (such as layout, etc.): reset the corresponding parameters.
Processing program is normal: check the preparation of the processing procedures, modify until it is normal.

XT laser is manufacturer of laser machines since 2004, any inquiry, feel free to contact us:

Email: xintian131@xtlaser.com

Skype: XTlaser-Flora

Mobile/Whatsapp/Wechat:0086 13153030563

Web: www.xtlaser.com

Youtube Homepage:https://www.youtube.com/feed/my_videos