How many years does a fiber laser marking machine take?-Angelina

How many years does a fiber laser marking machine take?

How many years does a fiber laser marking machine take?

I believe many people will ask this question.

Today to give you the calculation:Laser lifetime laboratory data is 100,000 hoursIf you work 24 hours a day, that’s 11 years.

If the laser attenuation is excluded and the mark cannot be marked on the workpiece, it can be used for six years based on the laser output of 40%.

Of course, this is the theoretical data.

According to the experience of XT laser, the optical fiber laser marking machine launched by our company has been used in the user site for five years.

And it is now running well.

The following summarizes a series of optical fiber marking machine maintenance specific methods.

1) when the fiber laser marking machine is not working, the marking machine and computer power should be cut off.

2) when the machine is not working, cover the field lens well to prevent dust from contaminating the optical lens.

3) the circuit of the machine is in a high-voltage state when it is working.

Non-professionals are not allowed to repair the machine at startup to avoid electric shock accidents.

4) the power should be cut off immediately in case of any fault.

5) if the device is used for a long time, the dust in the air will be absorbed on the surface under the focusing mirror.

If it is light, the power of the laser will be reduced, affecting the marking effect.

The most serious cause of the optical lens heat absorption so hot that burst.

When marking effect is not good, should carefully check the focus lens surface is contaminated.