Maintenance of fiber laser cutting machine (first part)-Flora | XTLASER

Maintenance of fiber laser cutting machine (first part)-Flora

Maintenance of fiber laser cutting machine

Maintenance of fiber laser cutting machine

  1. Clean the surface of the equipment to attach dust and cut slag.
  2. Check the joints of the capacitor signal module (at the cutting head) to confirm that the fastening is intact and there is no looseness.
  3. Clean up the water in the A/C storage tank.
  4. Equipment homing (including X, Y and Z axes)
  5. Clean waste scraps and debris in waste trailers
  6. Check the lubricating oil level in the lubricating oil pump. If it is not enough, fill it in time.
  7. Clean the dust on the A/C dust cover net and the water cooler dust cover net.
  8. Check the lubrication condition of each shaft slide rail, rack, gear and z-axis screw; and manually add lubricating oil on the upper end surface and the two end surfaces of the guide rail, and the main mechanical linkage end face of the rack, gear and lead screw is evenly distributed. Apply lithium grease. (If there is rust, be sure to remove the rust first.)
  9. Check the cooling water level of the water cooler, if not enough to raise it in time.
  10. Check the water pipes of the cooling water pipe to confirm that there is no extrusion, bending, grinding, scratching and water leakage; check the water pipe joints (push-in connectors and ordinary threaded joints) to confirm that the connection is normal and there is no water leakage.
  11. Check if the cooling water pressure gauge value is normal.
  12. Clean the water tank of the water cooler.
  13. Replace the water cooler to circulate cooling water.
  14. Change the water cooler filter.
  15. Clean the water filter of the water cooler.

XT laser is manufacturer of laser marking/engraving/cutting/welding/cleaning machines  since 2004, any inquiry, feel free to contact us:

Email: xintian131@xtlaser.com

Skype: XTlaser-Flora

Mobile/Whatsapp/Wechat:0086 18354256184

Web: www.xtlaser.com