How to make deep engraving with Ezcad software?-Eliza

How to make deep engraving with Ezcad software

 

Some customers wish to make deep engraving on metal parts by fiber laser marking machine. Yes, it is no problem. Fiber laser make deep engraving via repeat marking, marking and marking.

But if you wish to do deep engraving, first you need choose at least 30w and with small F-theta lens(70*70mm or 100*100mm working area). Because with same power, the bigger working area, the longer of focus length, then the weaker of laser beam when it works on metal surface.

If you have machine right now, you may follow below steps.

First oepn Ezcad software, input text, put it in center, then do filling. Because we need do deep engraving, so filling we can set 0.03mm or even more smaller. Power we can set 90%, speed at 500mm/s.

 

If you only keep this one parameter, after marking several time, you will find it cannot go more deeper because metal surface burned then metal powders gather and stays at marking place. Those slags prevent going deeper.

The better way is we set another parameter and using laser to clean the surface, then marking again. Cleaning needn’t high power. Parameters we can set filling 0.08mm or more, power 50%, speed 1000mm/s. Then put 2 TEXT together in center. The choose all content before marking.

 

Different colors means different parameters. If you think my description is not quite clear, then you may check this video, it will make everything more clearly.

The last, with more deeper, exceed 1mm, focus length will change, so you need adjust focus length a little to keep focus point at the metal surface. If you need relief results, you need choose 3D laser.
What content do you wish to know? Please leave message on below or send email to lasermachine01@xtlaser.com
Have a nice day !
Eliza

 

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published.